Dell 7CX5T Installation And Service Manual page 117

Steps
1. Using a Torx #T30 screwdriver, loosen the screws on the heat sink in the order below:
a. Loosen the first screw three turns.
b. Loosen the second screw completely.
c. Return to the first screw and loosen it completely.
2. Pushing both blue retention clips simultaneously, lift the processor and heat sink module (PHM).
3. Set the PHM aside with the processor side facing up.
Figure 70. Removing the processor and heat sink module
Next steps
1. Install the PHM.
Installing and removing system components 117