Table of Contents
Advertisement
Figure 31. Removing a drive blank
Next steps
1.
Install a drive
or
drive
blank.
Installing a drive blank
The procedure for installing 2.5 inch and 3.5 inch drive blanks is identical.
Prerequisites
1. Follow the safety guidelines listed in
Safety instructions
on page 65.
2. If installed,
remove the front bezel.
CAUTION:
Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Steps
Insert the drive blank into the drive slot, and push the blank until the release button clicks into place.
Figure 32. Installing a drive blank
Next steps
If removed,
install the front bezel.
Installing and removing system components
73
Advertisement
Table of Contents
