Table of Contents
Advertisement
Removing the processor from the processor and heat sink
module
Prerequisites
NOTE:
Only remove the processor from the processor and heat sink module if you are replacing the processor or heat
sink. This procedure is not required when replacing a system board.
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the air shroud.
4.
Remove the processor and heat sink module.
Steps
1. Place the heat sink with the processor side facing up.
2. Insert a flat blade screwdriver into the release slot marked with a yellow label. Twist (do not pry) the screwdriver to break the thermal
paste seal.
3. Push the retaining clips on the processor bracket to unlock the bracket from the heat sink.
Figure 71. Loosening the processor bracket
4. Lift the bracket and the processor away from the heat sink, and place the processor connector side down on the processor tray.
5. Flex the outer edges of the bracket to release the bracket from the processor.
NOTE:
Ensure that the processor and the bracket are placed in the tray after you remove the heat sink.
118
Installing and removing system components
Safety instructions
on page 65.
Before working inside your system
on page 66.
Advertisement
Table of Contents
