Table of Contents
Advertisement
TRENDnet User's Guide
Instance Settings
Advanced Settings > ERPS > Instance Settings
Parameter
Description
Instance Settings
Instance
Configures the instance ID. The valid value is from 1 to 31.
Control VLAN
Configures the control vlan for the instance. The valid value is
from 1 to 4094.
Data VLAN
Configures the data vlan for the instance. The valid value is
from 1 to 4094. It can be one or multiple vlans.
Instance Status
Instance
The instance ID.
Control VLAN
The control vlan of the instance.
Data VLAN
The data vlan of the instance.
© Copyright 2018 TRENDnet. All Rights Reserved.
Link Aggregation
Static Trunk
Link Aggregation (Trunking) is the grouping of physical ports into one logical higher-
capacity link. You may want to trunk ports if for example, it is cheaper to use multiple
lower-speed links than to under-utilize a high-speed, but more costly, single-port link.
However, the more ports you aggregate then the fewer available ports you have. A
trunk group is one logical link containing multiple ports. The Switch supports both static
and dynamic link aggregation.
Note: In a properly planned network, it is recommended to implement static link
aggregation only. This ensures increased network stability and control over the trunk
groups on your Switch.
Default Settings:
The default group Link Aggregation state is disabled for all groups.
The default group Link Aggregation load balance is source MAC and destination
MAC for all groups.
Maximum link aggregation group: 6
Maximum port in link aggregation group: 8
CLI Configuration
Node
Command
enable
show link-aggregation
link-aggregation
configure
[GROUP_ID] (disable |
enable)
configure
link-aggregation
[GROUP_ID] interface
PORTLISTS
Managed Industrial L2 Switch
Description
The command displays the current trunk
configurations.
The command disables / enables the trunk on
the specific trunk group.
The command adds ports to a specific trunk
group.
75
Advertisement
Table of Contents
