TRENDnet TI-RP262i User Manual page 127

TRENDnet User's Guide
Fiber Cable To indicate if the fiber cable is connected.
Connector Code of optical connector type.
Vendor Name SFP vendor name.
Vendor PN Part Number.
Vendor rev Revision level for part number.
Vendor SN Serial number (ASCII).
Date Code Manufacturing date code.
Notice: If the fiber cable is not connected, the Rx Power fields are not available.
© Copyright 2018 TRENDnet. All Rights Reserved.
Traffic Monitor
The function can be enabled / disabled on a specific port or globally be enabled disabled
on the Switch.
The function will monitor the broadcast / multicast / broadcast and multicast packets
rate. If the packet rate is over the user's specification, the port will be blocked. And if the
recovery function is enabled, the port will be enabled after recovery time.
Default Settings
Packet Packet
Port State Status Type
---- -------- ------- ----------- --------- -------- ---------
1 Disabled Normal Bcast
2 Disabled Normal Bcast
3 Disabled Normal Bcast
4 Disabled Normal Bcast
5 Disabled Normal Bcast
6 Disabled Normal Bcast
7 Disabled Normal Bcast
8 Disabled Normal Bcast
9 Disabled Normal Bcast
10 Disabled Normal Bcast
11 Disabled Normal Bcast
12 Disabled Normal Bcast
13 Disabled Normal Bcast
14 Disabled Normal Bcast
15 Disabled Normal Bcast
16 Disabled Normal Bcast
Managed Industrial L2 Switch
Recovery
Rate(pps) State Time(min)
1000 Enabled 1
1000 Enabled 1
1000 Enabled 1
1000 Enabled 1
1000 Enabled 1
1000 Enabled 1
1000 Enabled 1
1000 Enabled 1
1000 Enabled 1
1000 Enabled 1
1000 Enabled 1
1000 Enabled 1
1000 Enabled 1
1000 Enabled 1
1000 Enabled 1
1000 Enabled 1
124