TRENDnet TI-RP262i User Manual page 31

TRENDnet User's Guide
Basic Settings
General Settings
System
Management VLAN
To specify a VLAN group which can access the Switch.
⚫
The valid VLAN range is from 1 to 4094.
⚫
If you want to configure a management VLAN, the management VLAN should
be created first and the management VLAN should have at least one member
port.
Host Name
The hostname is same as the SNMP system name. Its length is up to 64 characters.
The first 16 characters of the hostname will be configured as the CLI prompt.
Default Settings
The default Hostname is [YOUR_DEVICE_NAME]
The default DHCP client is disabled.
The default Static IP is 192.168.10.200
Subnet Mask is 255.255.255.0
Default Gateway is 0.0.0.0
Management VLAN is 1.
CLI Commands
Node Command
configure Reboot
configure hostname STRINGS
configure interface eth0
© Copyright 2018 TRENDnet. All Rights Reserved.
Description
This command reboots the system.
This command sets the system's network
name.
This command enters the eth0 interface
node to configure the system IP.
eth0 Show
eth0 ip address A.B.C.D/M
eth0 ip address default-
gateway A.B.C.D
eth0 ip dhcp client
(disable|enable|renew)
eth0 management vlan
VLANID
Example: The procedures to configure an IP address for the Switch.
✓
To enter the configure node.
[DEVICE_NAME]#configure terminal
[DEVICE_NAME](config)#
✓
To enter the ETH0 interface node.
[DEVICE_NAME](config)#interface eth0
[DEVICE_NAME](config-if)#
✓
To get an IP address from a DHCP server.
[DEVICE_NAME](config-if)#ip dhcp client enable
✓
To configure a static IP address and a gateway for the Switch.
[DEVICE_NAME](config-if)#ip address 192.168.202.111/24
[DEVICE_NAME](config-if)#ip address default-gateway 192.168.202.1
Managed Industrial L2 Switch
This command displays the
configurations.
This command configures a static IP and
subnet mask for the system.
This command configures the system
default gateway.
This command configures a DHCP client
function for the system.
Disable: Use a static IP address on the
switch.
Enable & Renew: Use DHCP client to get an
IP address from DHCP server.
This command configures the management
vlan.
eth0
28