TRENDnet TI-RP262i User Manual page 50

TRENDnet User's Guide
configure qos mode wfq-queue
configure qos mode wrr-queue
weights VALUE VALUE
VALUE VALUE VALUE
VALUE VALUE VALUE
interface default-priority
interface no default-priority
enable show diffserv
configure diffserv
(disable|enable)
configure diffserv dscp VALUE
priority VALUE
© Copyright 2018 TRENDnet. All Rights Reserved.
its packets.
This command configures the QoS scheduling
mode to Weighted Fair Queuing.
This command configures the QoS scheduling
mode to Weighted Round Robin.
This command allows the user to specify a
default priority handling of untagged packets
received by the Switch. The priority value
entered with this command will be used to
determine which of the hardware priority
queues the packet is forwarded to. Default: 0.
This command configures the default priority
for the specific port to default (0).
This command displays DiffServ
configurations.
This command disables / enables the DiffServ
function.
This command sets the DSCP-to-IEEE 802.1q
mappings.
Web Configuration
Port Priority
Advanced Settings > Bandwidth Control > QoS
Parameter Description
Use this field to set a priority for all ports.
All Ports 802.1p
The value indicates packet priority and is added to the priority tag
priority field of incoming packets. The values range from 0 (lowest
priority) to 7 (highest priority).
Port This field displays the number of a port.
Select a priority for packets received by the port. Only packets
802.1p Priority without 802.1p priority tagged will be applied the priority you set
here.
Managed Industrial L2 Switch
47