TRENDnet TI-RP262i User Manual page 136

TRENDnet User's Guide
Maintenance
CLI Configuration
Node Command
enable show config- This command displays the configurations status if
change-status there are default values.
configure reboot This command reboots the system.
configure reload default- This command copies a default-config file to
config replace the current one.
Note: The system will reboot automatically to take
effect the configurations.
configure write memory This
configurations to the configuration file.
configure archive download- This command downloads a new copy of
config <URL PATH> configuration file from TFTP server.
Where <URL PATH> can be:
configure archive upload- This command uploads the current configurations
config <URL PATH> file to a TFTP server.
configure archive download- This command downloads a new copy of firmware
fw <URL PATH> file from TFTP / FTP / HTTP server.
Where <URL PATH> can be:
Example:
[DEVICE_NAME]#configure terminal
[DEVICE_NAME](config)#interface eth0
[DEVICE_NAME](config-if)#ip address 172.20.1.101/24
© Copyright 2018 TRENDnet. All Rights Reserved.
Description
command writes current
ftp://user:pass@192.168.1.1/file
http://192.168.1.1/file
tftp://192.168.1.1/file
ftp://user:pass@192.168.1.1/file
http://192.168.1.1/file
tftp://192.168.1.1/file
[DEVICE_NAME](config-if)#ip address default-gateway 172.20.1.1
[DEVICE_NAME](config-if)#management vlan 1
Enable the DHCP client function for the switch.
⚫
[DEVICE_NAME]#configure terminal
⚫
[DEVICE_NAME](config)#interface eth0
⚫
[DEVICE_NAME](config-if)#ip dhcp client enable
[DEVICE_NAME]#show config-change-status
The user configuration file is default.
The configurations have been modified.
Web Configuration
operating
Management > Maintenance > Configuration
Save Configuration
Press the Save button to save the current settings to the NV-RAM (flash).
Upload / Download Configuration to /from a your server
Managed Industrial L2 Switch
133