⑫ Trigger key
⑬ Sync output
terminal
⑭ Modulation
⑮ Burst
⑯ Sweep
⑰ Waveform
selection buttons
⑱ Power button
Rear Panel
①
20MHz reference
①
output
20MHz reference
②
input
③ External Trigger
/FSK/Burst
④ Modulation In
4.Quick Start
In Sweep and N-Cycle Burst, if you choose Source as
"Manual", every time you press this key, the generator will be
triggered once.
Output sync signal (see P32, "To Set the Sync Output")
Generate the Modulated waveforms
Generate burst for Sine, Square, Ramp, Pulse and Arbitrary
waveform
Sweep Sine, Square or Ramp waveform
Include: Sine, Square, Ramp, Pulse, Noise and Arbitrary
waveform. When a waveform is selected, the backlight of the
button turns on.
Turn on/off the generator
②
③
④
⑫
⑪
Figure 4-2 Rear panel overview
These two connectors are used to synchronize generators.
The connector [20MHz In] accepts an external 20 MHz
clock signal, and the connector [20MHz Out] can output a
20 MHz clock signal generated by the crystal inside the
generator. (See P35, "To Set the Clock Source")
This signal can be used as external signal source in Sweep,
FSK and Burst mode.
Modulation waveform input, use it as external signal
source
⑤
⑥
⑩
⑨
⑧
6
⑦