Set The Gated Burst; To Save And Recall; To Use Usb Storage - Owon AG4101 User Manual

Set the Gated Burst

Load
Start Phase
Gated
Waveform
Source
Waveform
Figure 5-19: The User Interface of Gated Burst
(1) When the output signal is Sine, Square, Ramp, Pulse or Arbitrary waveform, press
Burst function button to enter the Burst mode.
(2) Press ,
for instance, press
the parameters, please refer to "To set signals" on P11. Press
return to the Burst mode interface.
(3) Press F4 to switch to Gated.
(4) Press F3 to select Start Phase, define the Start and the Stop Point in a waveform.
The phase varies from -360° to +360°. For an Arbitrary Waveform, 0° is the first
waveform point.
(5) Press F5 to switch between Positive/Negative. Set the Polarity for the Gated
Signal.

To Save and Recall

Press Save function button to enter the file system.

To Use USB Storage

The storage location is divided into the internal storage (FLASH) and the U disk storage
(USBDEVICE). When a U disk is connected, the storage menu will show "USBDEVICE" and
"FLASH". Otherwise, the storage menu will show "FLASH" only.
(1) Install the U disk: insert a USB disk into the "⑩USB Host port" on the rear panel in
Figure 4-2, and the screen will show "Detect USB device". Press Save function button
to enter the file system, the storage menu will show "USBDEVICE" and "FLASH".
(2) Enter the storage: Turn the knob or press
desired storage. Press F1 to enter the chosen storage.
(3) Remove the U disk: Remove the U disk from the USB Host port on the rear panel.
5.Front Panel Operation
Current Parameter
, , or
to display the waveform and parameters. You can change
button to choose the waveforms. Take Sine
/ direction key to choose the
29
Positive
button again to