Pitney Bowes FastPac DI950 Operator's Manual page 143

SV61311 Rev. E
Figure 7.16: Clearance Between Envelope and
Side Guide
6. Verify the following:
• that there are sufficient funds for the job on the mailing system;
• that the MMI is working; and
• that the correct mode is set on the mailing system.
8. Press the Start button on the inserting system.
NOTE: The IntelliLink
interface to work. If the Control Center is not at the Main screen (for example,
in Sleep Mode), the "Postage Meter Unavailable" message will appear on the
inserter display screen.
The inserting system begins to assemble pieces of mail, which the mail-
ing system will then accept and process. The mailing system sends the
inserting system a message for each exiting piece of mail.
Clearing a Jam
If a jam occurs on the mailing system while processing mail with the MMI,
the "Remove Mailpiece" screen appears on the IntelliLink
Follow the steps below to clear the jam and resume processing mail.
1. Lift the mailing system cover(s) and remove the piece of mail from the
inside of the mailing system.
2. Select Clear to bypass error on the control center.
3. Press Start at the inserting system. Any mail remaining in the feeder is
printed, then the inserting system continues assembling and depositing
pieces of mail on the feeder.
Add-On Modules • 7
1/8 - 1/4"
Clearance
between
envelope
and Side
Guide
Control Center must be at the Main screen for the
®
Control Center.
®
7-17