Pitney Bowes FastPac DI950 Operator's Manual page 69

Creating a Job
(continued)
SV61311 Rev. E
3. If scanning is present on the system, the Create - Job Type screen dis-
plays.
• If the new job does not require scanning, select "Normal Type" to
continue.
• If the new job requires scanning, select "Scanning Job".
4. The Create Outer Envelope screen displays.
• If the job does not require an Outer Envelope, select "No".
• If the job requires an Outer Envelope, select "Yes."
- Select the appropriate Outer Envelope options for the job. Refer
to the Envelope Optons table in this chapter for more information
about each of the related menu options.
- Press "Accept" when done.
- If the job is a scanning job, the Create - Only One Envelope
screen displays. If the job requires only one envelope, select
"Yes" and proceed to step 5.
If the job requires an additional envelope, select "No, Two Outer
Envelopes". Validate the available options, and press "Accept"
when done.
NOTE: If this is a scanning job, and you will be using dynamic enve-
lope selection, you must select "No, Two Outer Envelopes".
5. The Create - Select Next Item screen displays. Select the appropriate
option.
Menu Options Associated Options/Actions
Reply Card a.
Reply Envelope
Pre-Folded Insert
Small Booklet
Slip
Generic Insert
Large Booklet
b.
Refer to the Insert Optons table in this chapter for specific
information about each of the related menu options.
If this is a scanning job, follow the steps below. Otherwise, go
to step b.
• The Scan Type screen displays. Select the appropriate
Scan Type (OMR, Code 3 of 9, or Interleaved 2 of 5.)
• The Scan Configuration screen displays. Select the
appropriate Scan Configuration.
• The Content - In Line with Marks screen displays. If there
s content n lne wth the scan marks, select "Yes". If there
s no content n lne wth the scan marks, select "No".
Select the appropriate options for the insert. Press "Accept"
when done.
Basic Operation • 3
3-27