Pitney Bowes FastPac DI950 Operator's Manual page 70

3 • Basic Operation
Creating a Job
(continued)
3-28
Menu Options Associated Options/Actions
Sheet (continued) a.
b.
c.
d.
6. Once you have finished adding a Sheet or Insert, the Add New Item
screen appears.
• Select "Yes" to add additional items to the job. Repeat step 4 as nec-
essary.
• Select "No" if you have finished adding items to the job.
7. The Create - Edit Job Settings screen displays. Select the appropriate
options.
Follow the appropriate step below:
• If ths s the frst sheet you are addng to the job and the
Attached Prnter s not present select the appropriate
personalization option. The Create - Verify Sheet screen
appears.
• If ths s the second sheet you are addng to the job select
either "Same Set (Fold with previous sheet)" or "New Set
(Fold separately.)" If the sheet is part of a new set, select
the appropriate personalization option.
• If ths s the frst sheet you are addng to the job and the
Attached Prnter s present select the appropriate printer
option. The Sheet - Personalized Create screen appears.
Select the appropriate personalization option. The Create
- Verify Sheet screen appears.
If this is a scanning job, follow the steps below. Otherwise, go
to step c.
• The Scan Type screen displays. Select the appropriate
Scan Type (OMR, Code 3 of 9, or Interleaved 2 of 5.)
• The Scan Configuration screen displays. Select the
appropriate Scan Configuration.
• The Content in Line with Marks screen displays. If there s
content n lne wth the scan marks, select "Yes". If there s
no content n lne wth the scan marks, select "No".
• If you selected "Yes", the Mark Locations Settings screen
appears. Follow the steps below to enter the various
mark-related measurements:
- Select an option, then use the UP/DOWN arrow keys
to enter the appropriate measurement (in millimeters).
- Press "Accept" when done entering the
measurement.
- Once all measurements have been entered, select
"Accept".
Select the appropriate Sheet options for the job. Press
"Accept" when done.
NOTE: If this is a scan job, be sure to set the Select Feed
setting.
Refer to the Sheet Optons table in this chapter for more
information about each of the related menu options.
Select the appropriate Fold options for the sheet. Press
"Accept" when done.
Refer to the Fold Optons table in this chapter for specific
information about each of the related menu items.
SV61311 Rev. E