Smbus Connector; Standby Power Led - DFI KD330-H110 User Manual

SMBus Connector

SMBus
1
5
2
The SMBus (System Management Bus) connector is used to connect SMBus devices. It is a
multiple device bus that allows multiple chips to connect to the same bus and enable each one
to act as a master by initiating data transfer.
Chapter 2 Hardware Installation
Chapter 2
PS/2 KB/MS
LAN 1
LAN 1

Standby Power LED

PS/2 KB/MS
LAN 1
LAN 1
This LED will lit red when the system is in the standby mode. It indicates that there is power
on the system board. Power-off the PC and then unplug the power cord prior to installing any
devices. Failure to do so will cause severe damage to the motherboard and components.
27
Standby Power LED
www.dfi .com