MEBX Configuration (KD330-Q170 only)
This section configures MEBX setting. Please refer to Chapter 6 for more information.
Chapter 3 BIOS Setup
Chapter 3
Debug Configuration
This section configures Debug setting.
Advanced
Dynamic EFI DEBUG
F1
Help
↑/↓
Select Item
Esc
Exit
←/→
Select Item
Dynamic EFI DEBUG
This field is used to turn on or off the function to output debug message from COM
port. If set to on, relevant EFI debug information will show up.
Advanced
Dynamic EFI DEBUG
EFI debug print level
EFI debug serial port
EFI debug baud rate
F1
Help
↑/↓
Select Item
Esc
Exit
←/→
Select Item
38
InsydeH2O Setup Utility
Enable it to output debug
<Off>
message from COM port.
F5/F6
Change Values
F9
Setup Defaults
Enter
Select
SubMenu
F10
Save and Exit
InsydeH2O Setup Utility
Enable it to output debug
<On>
message from COM port.
[0x80000000]
[0x3F8]
[115200]
F5/F6
Change Values
F9
Setup Defaults
Enter
Select
SubMenu
F10
Save and Exit
Rev. 5.0
Rev. 5.0
www.dfi .com