DFI KD330-H110 User Manual page 39

UEFI Device Manager
The section configures UEFI device with option ROM, such as LAN card, etc.
InsydeH2O Setup Utility
Advanced
UEFI Device Manager
UEFI Device Manager
Exit BIOS Setup Utility and launch Device Manager !!
F1 Help ↑/↓ Select Item
Esc Exit ←/→  Select Item
Chapter 3 BIOS Setup
Rev. 5.0
Device Manager Setting
[OK]
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit

Chapter 3
SIO NUVOTON6106D
This section configures the system super I/O chip parameters.
Advanced
SYS Smart Fan Control
Boundary 1
Boundary 2
Boundary 3
Boundary 4
Fan Speed Count 1
Fan Speed Count 2
Fan Speed Count 3
Fan Speed Count 4
CPU Smart Fan Control
Boundary 1
Boundary 2
Boundary 3
Boundary 4
Fan Speed Count 1
Fan Speed Count 2
Fan Speed Count 3
Fan Speed Count 4
SYS Smart Fan 2 Control
Boundary 1
Boundary 2
Boundary 3
Boundary 4
Fan Speed Count 1
Fan Speed Count 2
Fan Speed Count 3
Fan Speed Count 4
COM Port 1
Base I/O Address
Interrupt
RS485 Auto Flow
COM Port 2
Base I/O Address
Interrupt
F1 Help ↑/↓ Select Item
Esc Exit ←/→  Select Item
SYS Smart Fan, CPU Smart Fan, SYS Smart Fan 2 Control
Enable or disable the system/CPU smart fan/fan 2.
Boundary 1 to Boundary 4
Set the boundary temperatures that determine the operation of the fan with different
fan speeds accordingly. For example, when the system or the CPU temperature reaches
boundary temperature 1, the system or CPU fan should be turned on and operate at
the designated speed. The range is from 0-127
Fan Speed Count 1 to Fan Speed Count 4
Set the fan speed. The range is from 1-100% (full speed).
39
InsydeH2O Setup Utility Rev. 5.0
Enable/Disable Smart Fan
<Enable>
[30]
[40]
[50]
[60]
[30]
[40]
[50]
[75]
<Enable>
[30]
[40]
[50]
[60]
[30]
[40]
[50]
[75]
<Enable>
[30]
[40]
[50]
[60]
[30]
[40]
[50]
[75]
<Enable>
<3F8>
<IRQ4>
<Disable>
<Enable>
<2F8>
<IRQ3>
↓
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit

o C.
www.dfi .com