DFI KD330-H110 User Manual page 32

ACPI Configuration
This section is used to configure the system ACPI parameters.
InsydeH2O Setup Utility
Advanced
ACPI Confi guration
Wake on LAN <Enabled>
Wake On PS/2 <Disabled>
After G3 <Always On>
Wake On RTC <Disabled>
F1 Help ↑/↓ Select Item F5/F6
Esc Exit ←/→ Select Item Enter

Wake on LAN
This field is used to enable or disable the LAN signal to wake up the system.
Wake On PS/2
This field is used to enable or disable the PS/2 device to wake up the system.
After G3
This field is to specify what state to go when power is re-applied after a power
failure (G3 state).
Always On The system working state.
Always Off Off, except for trickle current to devices such as the power button.
Wake On RTC
Automatically power the system on at a particular time every day from the Real-time
clock battery.
Wake up time
When Wake On RTC is set to enabled, specify the wake up time of the day: <hour>
(00~23), <minute> (00~59), <second> (00~59).
Chapter 3 BIOS Setup
Chapter 3
Rev. 5.0
Determines the action tak-
en when the system power
is off and a PCI Power
Management Enable wake
up event occurs.
Change Values F9 Setup Defaults
Select SubMenu F10 Save and Exit

Note:
Under Dual Boot Type or UEFI Boot Type mode, if Quiet Boot is set to enabled,
BGRT Logo field will appear for configuration. Refer to the Boot menu for more
information.
Advanced
ACPI Confi guration
Wake on Lan <Enabled>
Wake On PS/2 <Disabled>
After G3 <Always On>
BGRT Logo <Enabled>
Wake On RTC <Disabled>
F1 Help ↑/↓ Select Item
Esc Exit ←/→  Select Item
BGRT Logo
This field is used to enable or disable to support display logo with ACPI BGRT table.
32
InsydeH2O Setup Utility Rev. 5.0
Support display logo with
ACPI BGRT table.
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit

www.dfi .com