DFI KD330-H110 User Manual page 42

Console Redirection
This section configures settings relevant to console redirection.
InsydeH2O Setup Utility
Advanced
Console Redirection Setup
Console Serial Redirect <Disabled>
F1 Help ↑/↓ Select Item F5/F6
Esc Exit ←/→  Select Item Enter
Console Serial Redirect
This field is used to enable or disable the console serial redirection function.
Chapter 3 BIOS Setup
Chapter 3
Rev. 5.0
Enable Console Redirec-
tion Function
Change Values F9 Setup Defaults
Select SubMenu F10 Save and Exit

When Console Serial Redirect is set to enabled, the screen will appear like below:
Advanced
Console Redirection Setup
Console Serial Redirect <Enabled>
Terminal Type <VT_100>
<115200>
Baud Rate
Data Bits <8 Bits>
Parity <None>
Stop Bits <1 Bit>
<None>
Flow Control
 COMA
Enable VT-100, 115200, N81
 COMB
Disable VT-100, 115200, N81
 COMC
Disable VT-100, 115200, N81
 COMD
Disable VT-100, 115200, N81

COME
Disable VT-100, 115200, N81
 COMF
Disable VT-100, 115200, N81

COMG
Disable VT-100, 115200, N81
 COMH
Disable VT-100, 115200, N81
 COMI
Disable VT-100, 115200, N81
 COMJ
Disable VT-100, 115200, N81
 Pci Serial Port 0:22:3
Disable VT-100, 115200, N81
F1 Help ↑/↓ Select Item
Esc Exit ←/→  Select Item
Terminal Type
Select terminal type: VT_100, VT_100+, VT_UTF8 or PC_ANSI.
Baud Rate
Select baud rate: 115200, 57600, 38400, 19200, 9600, 4800, 2400 or 1200.
Data Bits
Select data bits: 7 bits or 8 bits.
Parity
Select parity bits: none, even or odd.
Stop Bits
Select stop bits: 1 bit or 2 bits.
Flow Control
Select flow control type: none, RTS/CTS or XON/XOFF.
42
InsydeH2O Setup Utility
Rev. 5.0
Enable Console Redirec-
tion Function
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit

www.dfi .com