DFI KD330-H110 User Manual page 35

SATA Configuration
This section is designed to select the SATA controller and the type of hard disk drive which are
installed in your system unit.
InsydeH2O Setup Utility
Advanced
SATA Controller(s)
SATA Speed
SATA Mode Selection
Serial ATA Port 0 [Not Installed]
Port 0
Hot Plug
Serial ATA Port 1
[Not Installed]
Port 1
Hot Plug
Serial ATA Port 2
[Not Installed]
Port 2
Hot Plug
Serial ATA Port 3
[Not Installed]
Port 3
Hot Plug
Serial ATA Port 4
[Not Installed]
Port 4
Hot Plug
F1 Help ↑/↓ Select Item F5/F6
Esc Exit ←/→  Select Item Enter
SATA Controller(s)
This field is used to enable or disable Serial ATA devices.
SATA Speed
This field is used to select SATA speed generation limit: Auto, Gen1, Gen2 or Gen3.
SATA Mode Selection
The mode selection determines how the SATA controller(s) operates.
AHCI Mode
This option allows the Serial ATA devices to use AHCI (Advanced Host Controller Inter-
face).
RAID Mode (KD330-Q170 only)
This option allows you to create RAID or Intel Matrix Storage configuration on Serial
ATA devices.
Serial ATA Port 0, 1, 2, 3, 4 and Hot Plug
These fields are used to enable or disable the serial ATA port and its hot plug. Serial
ATA Port 4 is used to configure mSATA signal of Mini PCIe (for KD330-Q170 only).
Chapter 3 BIOS Setup
Chapter 3
Rev. 5.0
Enable/Disable SATA
<Enabled>
Device.
<Auto>
<AHCI>
<Enabled>
<Disabled>
<Enabled>
<Disabled>
<Enabled>
<Disabled>
<Enabled>
<Disabled>
<Enabled>
<Disabled>
Change Values F9 Setup Defaults
Select SubMenu F10 Save and Exit

USB Configuration
This section is used to configure the parameters of the USB device.
Advanced
Legacy USB Support <Enabled>
XHCI Hand-off <Disabled>
F1 Help ↑/↓ Select Item
Esc Exit ←/→  Select Item
Legacy USB Support
Disabled
Disable USB keyboard/mouse/storage support under UEFI and DOS environment.
Enabled
Enable USB keyboard/mouse/storage support under UEFI and DOS environment.
UEFI Only
Enable USB keyboard/mouse/storage support under UEFI environment.
XHCI Hand-off
Enable or disable to clear XHCI controller ownership change SMI bit by BIOS.
35
InsydeH2O Setup Utility Rev. 5.0
USB keyboard/mouse/stor-
age support under UEFI
and DOS environment. It
will supporting UEFI en-
vironment only if set to
UEFI Only
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit

www.dfi .com