Chassis Intrusion Connector; Front Panel Connector - DFI KD330-H110 User Manual

Chassis Intrusion Connector

PS/2 KB/MS
LAN 1
LAN 1
The board supports the chassis intrusion detection function. Connect the chassis intrusion
sensor cable from the chassis to this connector. When the system's power is on and a chassis
intrusion occurred, an alarm will sound. When the system's power is off and a chassis intrusion
occurred, the alarm will sound only when the system restarts.
BIOS Setting
Configure the chassis intrusion detection function in the Advanced menu ("SIO NUVO-
TON6106D" submenu) of the BIOS. Refer to the chapter 3 for more informaiton.
Chapter 2 Hardware Installation
Chapter 2

Front Panel Connector

PS/2 KB/MS
Chassis
Intrusion
1 Signal
2 Ground
HD-LED - Hard Drive LED
This LED will light when the hard drive is being accessed.
RESET - Reset Switch
This switch allows you to reboot without having to power off the system.
PWR-LED - Power/Standby LED
When the system's power is on, this LED will light. When the system is in the S1 (POS - Power
On Suspend) state, it will blink every second. When the system is in the S3 (STR - Suspend To
RAM) state, it will blink every 4 seconds.
ATX-SW - Power Switch
This switch is used to power on or off the system.
HD-LED
RESET
25
LAN 1
LAN 1
Pin Pin Assignment
3 HDD Power
5 Signal PWR-LED
7 Ground
9 RST Signal
ATX-SW
11 N.C.
1 2
PWR-LED
Front
HD-LED
Panel
RESET
ATX-SW
11 12
Pin Pin Assignment
2 LED Power
4 LED Power
6 Signal
8 Ground
10 Signal
www.dfi .com