SATO Argox I4 Series User Manual page 43

3 Printer operation
Ethernet settings and parameters
NO. Item
DHCP DISABLE
ENABLE
27
28
IP ADDRESS xxx.xxx.xxx.xxx
SUBNET xxx.xxx.xxx.xxx
29
MASK
DEFAULT xxx.xxx.xxx.xxx
30
GATEWAY
MAC
31
Read only
ADDRESS
Range Factory Default
If printer has been connected to a router, IP address will
be assigned automatically by DHCP server after power on.
If printer is not connected to a router, with DHCP disabled,
settings of IP ADDRESS, SUBNET MASK, and DEFAULT
GATEWAY settings will be available on LCD.
Every time when DISABLE is changed to be ENABLE, LCD
will prompt "ETHERNET CARD UPDATE FINISH..."
Then please reboot the printer.
xxx range:0~255
When DHCP is disabled, default IP address is
192.168.1.100.
If "_" sign appears, that means that DHCP setting is
disabled. On the contrary, DHCP setting is enabled.
1.
FEED/CONFIG. :
change contents.
(ex. from 000.000.000.000 to 255.255.255.255)
2.
PAUSE/CALIBR. :
shift "_"sign position.
(ex. from 255.255.255.255 to 255.255.255.255)
3.
CANCEL/RESET.:
Select next function setting. ("_" sign must at the third
digit of each parameter, for example, xxx).
4.
To change IP ADDRESS or
SUBNET MASK, enter DEFAULT GATEWAY setting, press
CANCEL button once; LCD will prompt "ETHERNET CARD
UPDATE FINISH..."
Then reboot the printer.
38
Front Panel
Remarks