SATO Argox I4 Series User Manual page 12

1 Introduction
LCD Display READY
CLEAR FLASH Blinking ON
CUTTER Blinking ON
FAILED
MEMORY FULL Blinking ON
MEMORY Blinking
INITIALIZED
PAUSE Blinking
PRINTHEAD Blinking
BROKEN
PRINT HEAD Blinking
OPEN
RESET Blinking
SERIAL IO Blinking
ERROR
SELF TEST ... Blinking
UPGRADING Blinking
FW.
RIBBON OUT Blinking
CALIBRATION . Blinking
..
MEDIA RIBBON
ON
ON
ON
ON ON
ON ON
ON ON
ON ON
ON ON
ON ON
ON ON
ON ON
ON Blinking
Blinking ON
7
Description
Clear flash memory.
Cutter has failed, or there is paper
jam inside the cutter.
Printer buffer is full caused by the
loaded soft fonts, graphics or
forms.
USB Memory is being initialized.
Printer is in PAUSE status. Media
sensor cannot index label gaps
Head broken error
Head latch is not closed.
Press CANCEL KEY + POWER ON to
reset NVR table.
The format or baud rate of the
RS232 communication is
inconsistent between the printer
and host.
Press FEED KEY + POWER ON to
print the self-test label.
Printer is receiving data
Ribbon is not installed or
end-of-ribbon occurred.
Press PAUSE KEY + POWER ON to
calibrate media.
Printer lights