Setting The Memories To Be Skipped - Yaesu FTM-400DR Operating Manual

4
Touch [2 MEM SCAN TYPE] and select "SELECT
MEM"
The setting will switch between"ALL MEM" and
"SELECT MEM" each time it is touched.
5
Press for one second or longer
The display will return to the previous screen.
6
Press
The function menu will be displayed.
7
Touch [SCAN]
The scan only those memory channels that have
been set to "SELECT" will be started.
Tips • The scan can also be started by pressing the [UP] or
[DWN] button on the microphone for one second or
longer.
• The scan will be performed in increasing order of the memory channel number.
• When a signal is received, the scanning stops for three seconds and then the scanning starts
again.
• To stop the scanning, either touch [SCAN] or press the microphone [PTT] button (the radio
will not transmit in this case).
Setting the memories to be skipped
Memory channels which you do not wish to receive can be skipped during scanning.
The channels to be skipped can be set using the following two methods:
(1) Designate channels using the memory list screen
(2) Sets channels individually using the function menu screen
(1) Designating channels to be skipped using the memory list screen
1
Touch [V/M] for two to three seconds (until the beep
sounds)
The memory list screen will be displayed.
2
Turn to select the memory to be skipped
Tip The memory can also be selected by touching it directly.
Signal Search
77