Initial Setting (Setting Is Required Only Once At The Beginning); Start The Transceiver - Yaesu WIRES-X TM-400XDE Instruction Manual

Initial Setting (setting is required only once at the beginning)

Start the transceiver

If the initial setting is completed in either "Portable Digital Node Mode" or "Portable HRI Mode", you can switch between the
two modes. It is recommended that you complete the initial setup in the same mode as you actually operate the PDN function.
◎ Portable Digital Node mode (Supports linking to the Internet only in C4FM digital mode)
 FT5DR/DE
1. Press and hold the [GM/X] key and [BAND] key and the POWER switch to turn the transceiver ON.
"WIRES-X PDN" is displayed on the LCD screen.
 FT3DR/DE
1. Press and hold the [X] key, [BAND] key and the POWER switch to turn the transceiver ON.
"WIRES-X PDN" is displayed on the LCD screen.
 FT2DR/DE
1. Press and hold the [X] key, [BAND] key and the POWER switch to turn the transceiver ON.
"PDN" is displayed on the LCD screen.
 FTM-400XDR/XDE or FTM-400DR/DE
1. Press and hold the [D X] key and the POWER switch to turn the transceiver ON.
"PDN" is displayed on the LCD screen.
 FTM-300DR/DE or FTM-200DR/DE
1. Press and hold the [D X] key and the POWER switch to turn the transceiver ON.
"WIRES-X PDN" is displayed on the LCD screen.
 FTM-100DR/DE
1. Press and hold the [D X] key and the POWER switch to turn the transceiver ON.
"PDN" is displayed on the LCD screen.
◎ Portable HRI Mode (Supports Internet communication in digital mode and analog mode)
 FT5DR/DE
1. Press and hold the [GM/X] key, [F
"WIRES-X" is displayed on the LCD screen.
 FT3DR/DE
1. Press and hold the [X] key, [BACK] key and the POWER switch to turn the transceiver ON.
"WIRES-X" is displayed on the LCD screen.
 FT2DR/DE
1. Press and hold the [X] key, [BACK] key and the POWER switch to turn the transceiver ON.
"WIRES-X" is displayed on the LCD screen.
 FTM-400XDR/XDE or FTM-400DR/DE
1. Press and hold the [D X] key, [GM] key and the POWER switch to turn the transceiver ON.
"YAESU" logo and "WIRES-X" logo is displayed on the LCD screen.
When connected to a PC and communicating with the WIRES-X software, "WIRES-X NODE" is displayed in the center of the screen.
 FTM-300DR/DE or FTM-200DR/DE
1. Press and hold the [D X] key, [GM] key and the POWER switch to turn the transceiver ON.
"YAESU" logo and "WIRES-X" logo is displayed on the LCD screen.
When connected to a PC and communicating with the WIRES-X software, "WIRES-X NODE" is displayed in the center of the screen.
 FTM-100DR/DE
1. Press and hold the [D X] key, [GM] key and the POWER switch to turn the transceiver ON.
"WIRES-X" logo is displayed on the LCD screen.
• Repeating the above operation will return the transceiver to the normal mode.
• To switch between "Portable Digital Node Mode" and "Portable HRI Mode", start with the normal mode first and then
perform the above operation.
] key and the POWER switch to turn the transceiver ON.
MENU
15