Installing The Controller - Yaesu FTM-400DR Operating Manual

Installing the Radio
Installing the controller
Install the controller using the provided bracket.
Caution
The bracket can be bent by hand to match the location where the controller is going to be installed.
Take due care not to injure yourself when bending the bracket.
1
Select the installation location
Caution Select a stable, flat location with as few dents and protrusions as possible.
Tip Also refer to "Installation location when used in a mobile unit" (
2
Fix the bracket to the controller using the
provided screws and washers, as shown in the
drawing
3
Peel off the protective seal from one side of the
provided two-sided adhesive sheet, and paste it
onto the bottom of the bracket
4
Peel off the other protection seal from the
underside of the two-sided adhesive sheet pasted
onto the bracket, and then stick the bracket to the
installation location
Caution Remove all dirt and dust from the installation
location before affixing the bracket.
28
P.24).
コントローラ
Controller
ブラケッ ト
Bracket
ワッシャー
Washer
ネジ
Screw
Two-sided
両面接着
adhesive
シート
sheet
保護シール
Protection seal
保護
Protection
シール
seal