Table of Contents
Advertisement
SPITFIRE MK
2) Using a modeling knife, cut away the covering
from the fuselage for the stabilizer and remove it.
Remove
the covering.
3) Draw a center line onto the horizontal
stabilizer. Then put the horizontal into the fuselage.
Center line
A
4) Check the fit of the horizontal stabilizer in its
slot. Make sure the horizontal stabilizer is square and
centered to the fuselage by taking measurements, but
don't glue anything yet.
Check to mark sure the wing and stabilizer are
paralell. If they are not, lightly sand the opening
in the fuselage for the stabilizer until the stabilizer
is paralell to the wing, but don't glue anything yet.
A
Item code: BH149.
Push in
A
B
B
A
A = A
Instruction Manual
5) With the horizontal stabilizer correctly aligned,
mark the shape of the fuselage on the top and bottom
of the tail plane using a water soluble / non permanent
felt-tip pen.
Mark line
Top side
6) Remove the stabilizer. Using the lines you just
drew as a guide, carefully remove the covering from
between them on the top and bottom of the tail plane
using a modeling knife.
When cutting through the covering to remove it, cut
with only enough pressure to only cut through the
covering it's self. Cutting into the balsa structure may
weaken it. This could lead to possible failure during
flight.
Top side and
bottom side.
1. ELEVATOR CONTROL HORN
INSTALLATION
Elevator control horn install as same as the way of
aileron control horn. Please see pictures below.
control horn
1. A+B Epoxy glue
Remove
the covering.
Bottom side.
2. Push in
11
Advertisement
Table of Contents
