Table of Contents
Advertisement
Operation Manual / TPL85-B14/-B15/-B16
7 Removal and installation / 7.1 Turbocharger weights
7 Removal and installation
7.1 Turbocharger weights
Weight [kg]
7.2 Removing the turbocharger
© Copyright 2018 . All rights reserved.
Lifting gear with a sufficient load limit must be used for removing and
installing the turbocharger. The following weight specification is the
heaviest variant possible. This standard value may deviate from the data
on the rating plate depending on the specification.
Disconnect all gas, air and oil lines in accordance with engine builder's
u
instructions.
CAUTION
Oil orifice plates
An orifice plate for adjusting the oil pressure is fitted in each of the two
oil inlet channels in the bearing casing. When the cartridge group, the
bearing casing or the turbocharger is fitted to the engine, it must be
ensured that the orifice plates that are specified for the turbocharger
have been installed in the two oil inlet channels.
Check correct installation of oil orifice plates.
u
Unplug cable connector on speed sensor.
u
Remove insulating shell from bearing casing.
u
Fasten each of two sets of lifting gear to each of two bearing casing
u
ribs provided for this purpose.
HZTL2491_EN
TPL85-B
12000
Revision C
August 2018
Advertisement
Table of Contents
