ABB HT842305 Operation Manual page 65

Table of Contents

Advertisement

Operation Manual / TPL85-B14/-B15/-B16
5 Maintenance / 5.5 Cleaning turbine blades and nozzle ring in opera-
tion
Points to remember when
cleaning
© Copyright 2018 . All rights reserved.
Set drain cock (9) in drain pipe (8) on gas outlet casing to Position 2
u
to keep drain pipe clean using air from compressor casing (21).
Disconnect water supply (1) to regulating valve (2).
u
After cleaning, wait with engine running for at least 10 minutes
u
without changing load to allow turbocharger to dry.
NOTICE
If the cleaning operation is not satisfactory, it may be repeated up to
two times.
If the cleaning result is still not satisfactory after three attempts and
the engine values are also unsatisfactory, we recommend that you have
the turbocharger inspected and cleaned by an official ABB Turbochar-
ging Service Station.
NOTICE
While the water is being injected, grinding noises might be heard at the
turbine end. These are caused by the turbine touching the cover ring
that shrinks due to cooling. This results in a minimal increase in the
clearance which, however, has no effect on the operating safety / reli-
ability.
¡
When cleaning, water must be drained from the gas outlet casing via
the drain pipe (8).
¡
The exhaust gas temperature following the turbocharger sinks dur-
ing cleaning (by 60 ... 180°C).
¡
Water might (but need not necessarily) flow out of the drain pipe, de-
pending on the engine load. This flow might not start for 2 ... 3
minutes, or it might not occur at all.
¡
If the drainage of the gas outlet casing is omitted, the turbocharger
speed and/or the gas inlet temperature must be monitored during
the cleaning process. If the load is too low, water can collect in the
gas outlet casing. Signs of this are a sudden significant drop in tur-
bocharger speed or a very strong increase in the gas inlet temperat-
ure. In such cases, cleaning must be stopped and the cleaning cycle
repeated from the beginning using a lower water pressure or higher
engine load.
HZTL2491_EN
Revision C
August 2018

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tpl85-b14

Table of Contents