Fitting Internal Part Of Compressor Casing - ABB HT842305 Operation Manual

Operation Manual / TPL85-B14/-B15/-B16
8 Disassembly and assembly / 8.9 Fitting internal part of compressor
casing

8.9 Fitting internal part of compressor casing

Fitting the diffuser
© Copyright 2018 . All rights reserved.
Fit O-rings (77005, 77006) to wall insert (77000).
u
Attach lifting gear and fit swivel lifting eyes (90230).
u
Align wall insert (77000) with threaded holes in internal part (76000)
u
of compressor casing using dog points on swivel lifting eyes (90230)
and then lower it.
Loop lifting gear around diffuser (79000), align it with holes and put
u
down into position.
Tighten screws (76002) as far as they will go and then back them off a
u
¼ turn. Leave screws loose and diffuser moveable.
Fasten lifting gear to lifting device (90190) and shackles (90195) of
u
support angle (90025).
HZTL2491_EN Revision C August 2018