Table of Contents
Advertisement
Operation Manual / TPL85-B14/-B15/-B16
2 Safety / 2.6 Safe operation and maintenance
© Copyright 2018 . All rights reserved.
Do not work on the turbocharger if you are under physical or mental
u
stress.
Work only with suitable tools as well as equipment and working ma-
u
terials that are in perfect condition.
Electric tools must be solidly earthed, and connecting cables may not
u
be damaged.
Keep the workplace clean, clear away loose objects and remove
u
obstacles on the floor.
Keep the floor, equipment and the turbocharger clean.
u
Have oil binding materials ready at hand and keep oil catch pans
u
ready or in position
Eliminate leaks.
u
Keep fire-protection materials and fire-extinguishing equipment
u
ready.
Welding work close to the turbocharger
If welding work is being carried out in the vicinity of the turbocharger,
u
cover the filter silencer so that the filter mat is not damaged.
Remove combustible objects and substances out of the range of fly-
u
ing sparks.
Cover all connections on the turbocharger so that no foreign objects
u
can get into the turbocharger.
Wear personal protective equipment (PPE) for welding operations.
u
Safety during start-up / commissioning and operation
Before starting work, carry out visual inspection of working area.
u
Remove any obstacles and objects lying around.
u
Before start-up / commissioning, check all pipes from and to tur-
u
bocharger for damage and leaks.
Don't work in any way that could impair safety when working on tur-
u
bocharger.
After about every 12 hours of operation or at least once a day, inspect
u
turbocharger for visible damage and defects.
Immediately report any damage or changes in operational perform-
u
ance to person responsible.
If damage is discovered, immediately shut down turbocharger and se-
u
cure it against inadvertent or unauthorized use.
When switching on auxiliary power sources (hydraulics, pneumatics,
u
electricity, water), keep an eye open for any hazards resulting from
supplying these power sources.
HZTL2491_EN
Revision C
August 2018
Advertisement
Table of Contents
