Lamp Installation / Replacement - PROEL DREAMLIGHT 250 ECLIPSE WASH User Manual

The lamp must never be ignited if the objective-lens or any housing-cover is
open, as discharge lamps may explode and emit a high ultraviolet radiation,
which may cause burns.
The maximum ambient temperature (T = 40°C) must never be exceeded.
a
CAUTION: The lens has to be replaced when it is obviously damaged, so that its
function is impaired, e. g. due to cracks or deep scratches!
Operate the device only after having familiarized with its functions. Do not
permit operation by persons not qualified for operating the device. Most
damages are the result of unprofessional operation.
CAUTION: the lamp has to be replaced when it is damaged or deformed due to
the heat!
Please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden
due to safety reasons!
Never remove the serial barcode from the device as this would make the
guarantee void.
If this device will be operated in any way different to the one described in this
manual, the product may suffer damages and the guarantee becomes void.
Furthermore, any other operation may lead to dangers like short-circuit, burns,
electric shock, lamp explosion, crash etc.

LAMP INSTALLATION / REPLACEMENT

DANGER: Install the lamp with the device switched off only. Unplug from mains
before.
For the installation you need one HSR250 / MSR250 lamp or equivalent,
respecting the manufacturer's specifications.
CAUTION: the lamp has to be replaced when it is damaged or deformed due to
the heat.
During the operation, the lamp reaches temperatures up to 600°C.
Before replacing the lamp, unplug mains lead and let the lamp cool down
(approx. 10 minutes)
24