Connection With The Mains - PROEL DREAMLIGHT 250 ECLIPSE WASH User Manual

DIAGRAM OF THE XLR-CONNECTION:
DMX-output DMX-input
XLR socket XLR socket
If you are using the recommended controllers, you can connect the DMX-output
of the controller directly with the DMX-input of the first fixture in the DMX-chain.
If you wish to connect DMX controllers with other XLR-outputs, you need to use
adapter-cables.
BUILDING A DMX-CHAIN:
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-
input of the next fixture. Always connect one output with the input of the next
fixture until all fixtures are connected.
CAUTION:
For all installation, having long signal cables
or in the presence of electrical noise, for
example a discotheque, it is recommended
practice to use a DMX terminator: this assist
in preventing corruption of the digital
control signal by external noise. The DMX
terminator is simply an XLR connector with a
120Ω (Ohm) resistor connected across pins
2 and 3, which is then plugged into the OUT
DMX socket on the last projector in the
chain. The connection are illustrated on the
right.

CONNECTION WITH THE MAINS

Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
28