Setup; Fuse Replacement; Fixture Linking; 3-Pin To 5-Pin Conversion Chart - PROEL PLLEDMLW18 User Manual

3. Setup

Disconnect the power cord before replacing a fuse and always replace with the same
type fuse.

3.1 Fuse replacement

With a flat head screwdriver wedge the fuse holder out of its housing. Remove the
damaged fuse from its holder and replace with exact same type fuse. Insert the fuse
holder back in its place and reconnect power.

3.2 Fixture linking

You will need a serial data link to run light show of one or more fixtures using a DMX-512
controller or to run synchronized on two or more fixtures set to a master/slave operating
mode. The combined number of channels required by all the fixtures on a serial data link
determines the number of fixtures the data link can support.
Maximum recommended serial data link distance:500 meters(1640ft).
Maximum recommended number of fixtures on a serial data link:32 fixtures.
Data cabling
To link fixtures together you must obtain data cables. If you choose to create your own
cable please use data-grade cables that can carry a high quality signal and are less
prone to electromagnetic interference.

3.3 3-Pin to 5-Pin conversion chart

Note! If you use a controller with a 5 pin DMX output connector. you will need to use a
5pin to 3 pin adapter
13