Lamp Adjustment - PROEL DREAMLIGHT 250 ECLIPSE WASH User Manual

During the installation do not touch the glass bulb bare-handed. Please follow
the lamp manufacturer's notes.
Do not install lamps with a higher wattage. Lamps with a higher wattage
generate temperatures that the device was not designed for. Damages caused
by non observance are not subject to warranty.
PROCEDURE
Unscrew the fixation screws (1, 2, 3) of the lamp cover and remove it.
Insert the new lamp into the lamp holder.
Replace the lamp cover and tighten the fixation screws (1, 2, 3)
Adjust the lamp as described in the next paragraph.
Do not operate this device with opened cover.

LAMP ADJUSTMENT

The lamp-holder is aligned at the factory. Due to differences between lamps,
fine adjustment may improve light performance.
Open the shutter, set the dimmer intensity onto 100% and direct the light on a
flat surface (wall for example). Center the hot-spot (the brightest part of the
beam) using the 3 adjustment screws "A, B, C". Turn one screw at a time to drag
the hot-spot diagonally across the projected image. If you cannot detect a hot-
spot, adjust the lamp until the light is even.
25