Accessories Shipped Together With The Machine; Installation Instructions; Rigging - PROEL PLHT575ML User Manual

ACCESSORIES SHIPPED TOGETHER WITH THE MACHINE

Main body of PAR moving head (1 pc)
-
XLR cable (1 pc)
-
User manual (1 pc)
-
Hook screw and secure screw
-

INSTALLATION INSTRUCTIONS

This product is fit to be used indoors, its ambient operating temperature lower
-
than 35°C.
People assigned to install, operate and maintain the product must familiarize
-
themselves with the performance of the light fixture before they begin the
operations. Most damages result from incorrect operations arising out of
unfamiliarity with the performance of the product.
Before the product begins to be used for the first time, please open the package
-
to check if there are any damages caused during transportation
Before replace the lamp, please make sure the power have been cut off, and wait
-
until the light cool down (the temperature of the lamp can reach 200°C or more).
Open the lamp lid , and replace the lamp . Be care not to touch the surface of the
-
new lamp.
Close the lid.
-
Install the light fixture in a place that is well ventilated. Pay attention to checking if
-
the fan and fan net are smooth.
The BUG TUBE PAR64 moving head uses the 3A/250V safety fuse. Please use
-
a fuse of the same specification.

RIGGING

DANGER TO LIFE: Please consider the respective national norms during the
installation. The installation must only be carried out by an authorized dealer.
The installation must always be secured with a secondary safety attachment safety
rope). This secondary safety attachment must be constructed in a way that no part of
the installation can fall down if the main attachment fails. A safety rope which already
hold the strain of a crash or which is defective must not be used again.
1. Omega-holders
2. Clamps (optional)
3. Screw
4. Safety-rope
Unscrews 4 screws (3) on the base. Screw one clamp each via a M12 screw and nut
onto the Omega-holders. Insert the quick-lock fasteners of the first Omega-holder into
the respective holes on the bottom of the device. Tighten the quick-lock fasteners fully
clockwise. Install the second Omega-holder.
Use 2 appropriate clamps to rig the fixture on the truss; make sure that the device is
fixed properly; make sure that the structure (truss) to which you are attaching the
fixture is secure.
12