PROEL DREAMLIGHT 250 ECLIPSE WASH User Manual page 33

DEMO OPERATION
The PLML250E moving head works also without a connection to an external
controller. Press the MODE
Operation mode. Press UP
N
function, select
RESET
The PLML250E moving head resets all channels also without a connection to an
external controller. Press the MODE
Operation mode. Press UP
N
function, select
CONTROLLING
After having addressed all PLML250E , you may now start operating these via
your lighting controller.
Note:
After switching on, the PLML250E will automatically detect whether DMX 512
data is received or not. If there is no data received at the DMX-input, the display
will start to flash "A001" with actually set address.
This situation can occur if:
the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with
the input of the PLML250E, or the controller is switched off or defective.
LAMP
The PLML250E is to be operated with a HSR 250 or MSR 250 lamp.
MODE button and select MODE MODE
UP button and when the display shows UP UP
on the display and press ENTER
MODE button and select MODE MODE
UP button and when the display shows UP UP
on the display and press ENTER
F4
to enter into the Demo
ENTER to confirm.
ENTER ENTER
F5
to enter into the Demo
ENTER to confirm. ENTER ENTER
Y
. To disable this
Y
. To disable this
32