Safety Instructions - PROEL DREAMLIGHT 250 ECLIPSE WASH User Manual

SAFETY INSTRUCTIONS

CAUTION: BE CAREFUL WITH YOUR OPERATIONS. WITH A DANGEROUS
VOLTAGE YOU CAN SUFFER A DANGEROUS ELECTRIC SHOCK WHEN TOUCHING
THE WIRES.
This device has left our premises in absolutely perfect condition. In order to
maintain this condition and to ensure a safe operation, it is absolutely necessary
for the user to follow the safety instructions and warning notes written in this
user manual.
IMPORTANT: Damages caused by the disregard of this user manual are not
subject to warranty.
If the device has been exposed to drastic temperature fluctuation (e.g. after
transportation), do not switch it on immediately. The arising condensation water
might damage your device. Leave the device switched off until it has reached
room temperature.
This device falls under protection-class I. The power plug must only be plugged
into a protection class I outlet.
Never let the power-cord come into contact with other cables! Handle the
power-cord and all connections with the mains with particular caution!
Make sure that the available voltage is not higher than stated on the rear panel.
Make sure that the power-cord is never crimped or damaged by sharp edges.
Check the device and the power-cord from time to time.
Always disconnect from the mains, when the device is not in use or before
cleaning it. Only handle the power-cord by the plug. Never pull out the plug by
tugging the power cord.
During the initial start-up some smoke or smell may arise. This is a normal
process and does not necessarily mean that the device is defective.
CAUTION: during the operation, the housing becomes very hot.
DANGER OF BURNING: never install the device on a highly flammable surfaces
(e.g. fair carpet).
22