Dmx-Connection - PROEL DREAMLIGHT 250 ECLIPSE WASH User Manual

DANGER OF FIRE: when installing the device, make sure there is no highly-
inflammable material (decoration articles, etc.) within a distance of min. 1 m.
CAUTION!
Use 2 appropriate clamps to rig the fixture on the truss. Screw one clamp each
via a M12 screw and nut onto the omega holders. Insert the quick-lock fasteners
of the first omega holder into the respective holes on the bottom of the device.
Tighten the quick-lock fasteners fully clockwise. Install the second omega
holder.
Make sure that the device is fixed properly.
Ensure that the structure (truss) to which you are attaching the fixtures is secure.
The Moving-Head can be placed directly
on the stage-floor or rigged in any
orientation on a truss without altering its
operation characteristics (see the
drawing).
For overhead use, always install a safety-
rope. Pull the safety rope through the ole
on the bottom of the base.
Use a safety rope exclusively as a closed
ring. Never use by only securing at each
end. The maximum drop distance must
never exceeded 20 cm.
A safety rope which already hold the
strain of a crash or which is defective must
not be used again.

DMX-CONNECTION

The DMX wires must not come into contact with each other, otherwise the
fixtures will not work at all, or will not work properly.
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to
connect the controller with the fixture or one fixture with another.
27