Operation; Installing/Replacing The Lamp; Basic Service - PROEL PLFON200 User Manual

OPERATION

After you connected the effect to the mains, the fixture starts running. During the reset, the motors are
trimmed and the device is ready for use afterwards.
The focus is adjusted rotating the objective lenses. This is easiest to do without any type of movements.
Rotating on the left or on the right until a sharp image is acquired.

INSTALLING/REPLACING THE LAMP

Warning Isolate electrically before re-lamping. The lamp shall be changed if it becomes damaged or
thermally deformed.
Caution: very hot lamp.
Only the dichroic lamp 12V – 100W is supported (PROEL PLLP10012D)
Warning Installing any other lamp may damage the fixture!
Disconnect the fixture from power and allow it to cool for 20 minutes.
-
Remove 2 knobs on the rear side and open the lamp housing.
-
Grasp the old lamp and slide it carefully out of the lamp holder.
-
Pull the socket off the lamp. Do not pull the wires.
-
Clean the glass bulb and reflector with a cloth, particularly if your fingers touched the glass. A clean,
-
lint-free cloth wetted with alcohol is best.
Gently close the lamp housing and screw 2 knob.
-

BASIC SERVICE

Warning: the exterior of the fixture can become hot. Always disconnect the fixture from AC power and
allow to cool for at least 20 minutes before handling or opening.
Regular cleaning of the elements in the optical path, as well as the air vents, is vital to maintaining the
operational quality of the PLFON200 - PLFON205.
Important! Excessive dust, smoke fluid, and particulate buildup degrades performance and causes
overheating and damage to the fixture that is not covered by the warranty.
Cleaning the air vents:
To maintain adequate cooling, dust must be cleaned from the air vents periodically. Remove dust from
the air vents with a soft brush, cotton swab, vacuum, or compressed air.
Cleaning optical components:
Clean the optical components regularly. The presence of smudges or dust on optical surfaces can
reduce the strength of the light output and the quality of the effects.
Use care when cleaning optical components and work in a clean, well lit area. The coated surfaces are
fragile and easily scratched. Do not use solvents that can damage plastic or painted surfaces.
9