Table of Contents
Advertisement
Chapter 7 Appendix — Installing the Interface Board (optional)
How to remove the Interface Board
1)
Remove the Interface Board. (Fig. 1)
f Remove the four screws fixing the Interface Board by rotating counterclockwise with a Phillips screwdriver.
The removed screws are used to fix the slot cover.
f Hold the handle of the Interface Board and remove it slowly.
2)
Attach the slot cover.
f Attach the stored slot cover, and tighten and fix with the four screws removed in Step 1).
f To replace with other Interface Board, attach the Interface Board following the procedure in "How to install
the Interface Board" (x page 318).
Attention
f Always attach the slot cover on the blank slot.
f Store the removed Interface Board inside an antistatic bag.
Handle
Fig. 1
ENGLISH - 319
Advertisement
Table of Contents
