Table of Contents
Advertisement
Appendix
Limitation
❒ There may be a difference in the size of the image when it is printed at the des-
tination.
❒ If you place an original larger than A3, 11"×17" on the exposure glass, only an
A3, 11"×17" area is scanned.
Note
❒ Even if an original is correctly placed on the exposure glass or in the ADF, a
margin of 3 mm (0.1") around each edge of the original may not be sent.
❒ If the receiver uses paper of a smaller width than the original, the image will
be reduced to fit that paper. See p.68 "Auto Reduce".
❒ The machine detects paper sizes in the following ways:
• When you place an original in the ADF, an original wider than about 264
mm (10.4") is scanned as A3, 11"×17" size.
An original narrower than about 230 mm (9.1") will be sent as 8
1
8
/
2
Originals up to 1,200 mm (47.2") in length can be scanned.
• Refer to the table below for sizes the machine can detect when you place
an original on the exposure glass. Because the machine scans non-standard
size documents in a standard size, part of the image may be truncated de-
pending on the length of the document. For details about how to set non-
standard size documents, see p.14 "Setting a Scan Area", Facsimile Refer-
ence <Basic Features>.
❖ ❖ ❖ ❖ Metric Version
-243 mm
243 mm-
268 mm
268 mm-
❖ ❖ ❖ ❖ Inch Version
11
9.6"-10.6"
10.6"-
× - Unable to auto detect
*1
Normally a length of about 420 mm (16.5") can be scanned; however, it is only possi-
ble to specify a scanning size up to 432 mm (17").
182
"×14" size.
-249 mm
×
B5 JISK
A4K
-9.8"
×
-9.6"
1
11"×8
/
"K
2
1
11"×8
/
"K
2
*1
Length
249 mm-274 mm 274 mm-316 mm
B5 JISL
B4 JISL
B4 JISL
A3L
*1
Length
9.8"-10.8"
10.8"-12.4"
×
1
8
11"×17"L
11"×17"L
11"×17"L
11"×17"L
1
/
"×11" or
2
316 mm-
A4L
FL
B4 JISL
A3L
A3L
12.4"-
/
"×11"L
FL
2
11"×17"L
11"×17"L
Advertisement
Table of Contents
