Gestetner 2045 Fax Manual page 60

Key Operator Setting
❒ If you select "OFF" for Author-
ized RX in "Initial Set Up", the
settings will be the same as the
Reception Mode settings. See
p.132 "Reception Setting".
❒ You can change Special Senders
in the same way as you pro-
gram them.
❖ ❖ ❖ ❖ Forwarding
Use this function to print received
messages, and then transfer them
to those receivers registered be-
forehand.
It is also possible to forward faxes
sent only by senders programmed
as Special Senders.
Note
❒ To use this function, register
your Special Senders, and then
select "ON" for "Forwarding"
in "Reception Setting". See
p.132 "Reception Setting".
❒ If you specify "ON" in "For-
warding" and select [Same as ba-
sic settings], the fax message will
be forwarded to the other ends
programmed in "Specify End
Receiver". See p.143 "Forward-
ing".
9
❒ If you do not program any Spe-
cial Senders, the machine trans-
fers all incoming documents to
the other end specified in "Spec-
ify end Receiver".
❖ ❖ ❖ ❖ Reception File Print Quantity
Use this function to print the spec-
ified number of copies of docu-
ments received from programmed
senders (Special Senders). If you
do not register any Special Send-
ers, the machine prints the speci-
fied nu mber of copies for all
received documents.
154
Limitation
❒ You cannot use multi-copy
printing with Polling Reception,
Free Polling, Confidential Re-
ception, or Memory Lock.
Note
❒ You can specify up to 10 copies.
❖ ❖ ❖ ❖ Print 2 Sided
The optional duplex unit is required.
Use this function to print on both
sides of paper.
Limitation
❒ If you select the bypass tray for
the "Paper Tray", duplex print-
ing is disabled.
❖ ❖ ❖ ❖ Memory Lock
Use this function to store incoming
documents from registered send-
ers (Special Senders) in memory
without printing them. People
without the Memory Lock ID can-
not print the documents, and
therefore this function is useful for
receiving confidential documents.
If you do not register any senders,
the machine receives fax message
from all senders using Memory
Lock reception.
Reference
p.171 "Programming a Memory
Lock ID"
Limitation
❒ If you program the same sender
in Memory Lock and Forward-
ing, Forwarding is disabled.
❖ ❖ ❖ ❖ Reception Reverse Printing
Use this function to print the pages
in reverse order. See p.88 "Reverse
Order Printing".