Gestetner 2045 Fax Manual page 50

Key Operator Setting
Programming an end receiver
A A A A
Press the { { { { User Tools/Counter} } } } key.
B B B B
Press [Facsimile Features].
C C C C
Select [Key Operator Tools].
D D D D
Select [Forwarding].
E E E E
Press [ON].
Note
❒ If there is an end receiver al-
ready programmed, a receiver
name is shown. If you want to
change the receiver, press [Re-
9
ceiver] and proceed to step
❒ To cancel "Forwarding", press
[Cancel] and proceed to step
144
F F F F
Specify an end receiver using the
Destination list, and then press
[OK].
The receiver name is shown to the
right of [Receiver].
If you make a mistake, press [Clear]
or the { { { { Clear/Stop} } } } key before
pressing [OK], and then try again.
G G G G
Press [OK].
H H H H
Press the { { { { User Tools/Counter} } } } key.
The initial display appears.
Quitting the forwarding function
A A A A
Press the { { { { User Tools/Counter} } } } key.
F
.
B B B B
H
.
Press [Facsimile Features].
C C C C
Select [Key Operator Tools].
D D D D
Select [Forwarding].