Gestetner 2045 Fax Manual page 59

❖ ❖ ❖ ❖ Using a Full agreement
Destination to be
registered
(Own Name)
NEW YORK
BRANCH
HONG KONG
BRANCH
SYDNEY
BRANCH
❖ ❖ ❖ ❖ Using a Partial agreement
Destination to be
registered
(Own Name)
BRANCH
Note
❒ You can program up to 30 wild
cards (50 with the optional fax
function upgrade unit).
❒ Spaces are ignored when identi-
fications are compared.
❒ You can use wild cards for the
following functions:
• See p.155 "Program-
ming/Changing Special
Senders".
• See p.156 "Authorized RX
(Authorized Reception)".
• See p.156 "Forwarding".
Limitation
❒ You cannot register senders as
Special Senders if they do not have
Own Name or Own Fax Number
programmed.
❒ The machine cannot differentiate
between Polling Reception and
Free Polling documents from Spe-
cial Senders.
Number of
registered
identifications
3
Number of
registered
identifications
1
Using Key Operator Settings
Note
❒ You can program up to 24 charac-
ters for the sender.
❒ You can check Own Name and
Own Fax Number using the Jour-
nal. You can check programmed
Special Senders using the specified
sender list. See p.23 "Printing the
Journal". See p.160 "Printing the
Special Sender list".
❒ If you select "OFF" for the Special
Sender function in "Initial Set Up",
the settings will be the same as the
Reception Mode settings. See p.132
"Reception Setting".
❖ ❖ ❖ ❖ Authorized Reception
Use this function to limit incoming
senders. The machine only re-
ceives faxes from programmed
Special Senders, and therefore, it
helps you screen out unwanted
messages, such as junk mail, and
saves wasting fax paper.
Note
❒ To use this function, program
the Special Senders function,
and then select "ON" in "Au-
thorized RX" with "Reception
Setting". See p.132 "Reception
Setting". See p.147 "Changing
the User Parameters" (switch
08, bit 2).
❒ Without
registering
Senders, the Authorized RX
function will not work, even if
you select "ON".
❒ You can select to receive only
from registered senders or re-
ceive only from senders other
than those registered in "User
Parameters". See p.147 "Chang-
i n g t h e U s e r P a r a m e t e r s "
(switch 08, bit 2).
9
Special
153