Table of Contents
Advertisement
F F F F
Enter a horizontal size using the
number keys.
Note
❒ You can specify a horizontal
length from 128 to 1,200 mm or
from 5.5 to 47 inches. You can-
not specify a length shorter than
128 mm or longer than 1,200
mm.
❒ Each time you press [mm] or
[inch], the units swich between
"mm" and "inch". If you enter a
length and change the units by
pressing [mm] or [inch], the
length is converted automati-
cally according to the unit (frac-
tions are rounded off). For
example, when you enter { { { { 2} } } } ,
{5} } } } , and { { { { 0} } } } in millimeters and
change to "inch", the length "9.8
inch" is shown on the display. If
you press [mm] or [inch] again,
"249 mm" is displayed.
❒ If you make a mistake, press
[Clear] or the { { { { Clear/Stop} } } } key,
and then try again.
❒ To cancel a scan size, press [Can-
cel].
Using Key Operator Settings
G G G G
Select a vertical size, and then
press [OK].
Note
❒ A displayed vertical size differs
depending on the selected unit.
When [mm] is selected, [Auto De-
tect], [210mm (A4)], [257mm(B4
JIS)], [297mm (A3)], [216mm (8
and [279mm (11)] are shown.
When [inch] is selected, [Auto De-
tect], [8.3inch (A4)], [10.1inch(B4
JIS)], [11.7inch (A3)], [8.5inch], and
[11.0inch] are shown.
❒ To cancel a scan size, press [Can-
cel].
H H H H
Press [Exit].
I I I I
Press the { { { { User Tools/Counter} } } } key.
The initial display appears.
1
/
)],
2
9
141
Advertisement
Table of Contents
