Table of Contents
Advertisement
Figure 93. Installing drive backplane
Next steps
1
Connect all the cables to the backplane.
2
Install all the drives.
3
Install the backplane cover.
4
Install the air shroud.
5
Follow the procedure listed in
Related link
Installing a drive carrier
Installing the backplane cover
Installing the air shroud
Removing the 3.5 inch rear drive backplane
Prerequisites
CAUTION:
To prevent damage to the drives and backplane, you must remove the drives from the system before removing the
backplane.
CAUTION:
You must note the number of each hard drive and temporarily label them before removal so that you can replace them
in the same locations.
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
Remove all the drives from the rear drive cage.
136
Installing and removing system components
After working inside your
system.
Safety
instructions.
Before working inside your
system.
Advertisement
Table of Contents
