Extron electronics DXP DVI Pro User Manual page 103

Contents
procedures for using the software to control and configure the DXP.
Switcher information
menu options; they display information about your switcher:
Model — DXP model name
Config
Firmware Ver. — Firmware version to second decimal place
LoggedOn as:
Connection – (For RS-232 or RS-422) "Com n" –
About this Program
version of the Matrix Switcher Control Program.
Using Emulation Mode
computer.
NOTE:
1. Double-click the
2. On the Comm Port Selection window, select
3.
extension), then click
Figure 98.
NOTE:
— The two sections below the
— Opens a window that displays information about the current
In emulation mode, you can emulate any matrix switcher that is supported by
the Matrix Switcher Control Program; you are not limited to the DXP.
MATRIX Switchers + Control Program
Open
.
Selecting an Emulation File
Demo.mtx
Selecting the
New.ini
setup. Selecting the
setup screen to get you started.
Contents
n n n n
x ) A( x )
baud rate
Emulate
, then click
file provides a sample of a completed matrix
Cancel
file or clicking
option are not
," or (for IP)
OK
.
provides a blank
97 97