Table of Contents
Advertisement
The image is distorted or runs off. – Check PC adjust menu or Screen menu and adjust them.
PIN code dialog box appears – PIN code lock is being set. Enter a PIN code (the "1234"
at start-up .
The Remote control does
not work .
Indicator blinks or lights.
The exclamation mark appears
on the screen.
Top control does not work. – The top control is not available if the top control is locked at
Unable to unlock the Logo PIN
code lock, Security key lock
or Security PIN code lock.
WARNING :
High voltages are used to operate this projector. Do not attempt to open the cabinet.
If problems still persist after following all operating instructions, contact the dealer where you
purchased the projector or the service center. Specify the model number and explain about the
problem. We will advise you how to obtain service.
The CE Mark is a Directive conformity
mark of the European Community (EC).
See pages 29-30, 34-35.
or number you have set). See pages 19, 55-56.
– Check the batteries.
– Make sure no obstruction is between the projector and
remot controller.
– Make sure you are not too far from the projector when
using the remote control. Maximum operating range
is 16.4'(5 m).
– Make sure the code of the remote control is conformed to
the projector's code. See page 54.
– Unlock the Key lock function for the remote control function.
See page 55.
– Check the status of the projector with referring to
"Indicators and projector Condition". See page 70.
– Your operation is invalid. Operate correctly.
Key lock under Security of Setting section. See page 55.
–
Contact the dealer where you purchased the projector or
the service center.
Appendix
This symbol on the nameplate
means the product is Listed
by Underwriters Laboratories
Inc. It is designed and
manufactured to meet rigid U.L.
safety standards against risk
of fire, casualty and electrical
hazards.
67
Advertisement
Table of Contents
