Eiki LC-WB200W Owner's Manual page 45

Auto setup
This function enables Input search, Auto PC
adj. and Auto Keystone adjustment by pressing
the AUTO SETUP button on the top control or
the AUTO SET button on the remote control.
Settings for those functions can be altered as
follows:
Input search
This function detects the input signal
automatically. When a signal is found, the search
will stop. Use the Point ▲▼ buttons to select
one of the following options.
Off ....... Input search does not work.
On 1..... Input search works under the following
situation.
– When pressing the AUTO SET
button on the remote control.
– When pressing the AUTO SETUP
button on the top control.
On 2......Input search works under the following
situation.
– When turning on the projector by
pressing the ON/STAND-BY button
on the top control or the remote
control.
– When pressing the AUTO SET button
on the remote control.
– When pressing the AUTO SETUP
button on the top control.
– When the current input signal is cut
off.*
* If the No show or Freeze function is active,
cancel it to activate the Input search. It is
also unavailable when On-Screen menu is
displayed.
Auto PC adj.
On...............Enables Auto PC Adjustment when
pressing the AUTO SET button
on the remote control or the AUTO
SETUP button on the top control.
Off...............Disables Auto PC Adjustment.
Auto keystone
Auto..........Always works and corrects
keystone distortion according to the
projector's tilt.
Manual......Works only when pressing the
AUTO SET button on the remote
control or the AUTO SETUP button
on the top control.
Off.............Disables Auto Keystone.
Note:
• While Input search is set to On 1 or On 2, the
status of Input and Lamp are displayed every time
the signal is switched.
• Only the last selected input source can be
detected.
Auto setup
Note:
• During Input search is in progress, If the MENU
button or the ON/STAND-BY button is pressed,
Input search will stop. If the COMPUTER 1/2 or
VIDEO or COMPONENT or S-VIDEO or HDMI
button is pressed, Input search will stop and go
back to the button's input signal.
• Input search, Auto PC adj. and Auto keystone
can not be set Off at the same time.
• Auto keystone corrects vertical distortion only,
not correct horizontal distortion.
• The Auto keystone function can not work when
the Ceiling feature is set On in the Screen menu
(pp. 35, 43).
• Perfect correction of the image distortion can not
be ensured with the Auto setup function. If the
distortion is not corrected properly by pressing the
AUTO SETUP or the AUTO SET button, adjust
manually by pressing the KEYSTONE button on
the remote control or selecting Keystone in the
Setting menu (pp. 35, 43).
• Fine sync, Total dots, Horizontal and Vertical of
some computers cannot be fully adjusted with the
Auto PC Adjustment function. When the image is
not provided properly with this operation, manual
adjustments are required (pp. 30-31).
Setting
45