Eiki LC-WB200W Owner's Manual page 47

Table of Contents

Advertisement

Capture
This function enables you to capture an image
being projected to use it for a starting-up
display or interval of presentations.
Select Capture and press the SELECT button.
A confirmation box appears and select Yes to
capture the projected image.
After capturing the projected image, go to the
Logo select function and set it to User. Then
the captured image will be displayed the next
time you turn on the projector or when you
press the NO SHOW button (p. 26).
To cancel the capture function, select Yes in
the Quit? confirmation box.
Note:
• Before capturing an image, select Standard in
the Image select Menu to capture a proper image
(pp. 32 ,39).
• The output image resolution from a computer can
be supported up to the panel resolution (1280 x
800).
• When capturing the image that has been adjusted
by the Keystone function, the adjusted data is
automatically reset and the projector captures an
image without keystone correction.
• When Logo PIN code lock function is set to On,
Logo select and Capture can not be selected.
• When starting to capture a new image, the
previously stored image is cleared even if you
cancel the capturing.
• When there is no captured image or it is
interrupted while capturing an image, User can
not be selected, you can only switch between
Default and Off.
Logo PIN code lock
This function prevents an unauthorized person
from changing the screen logo.
Off .......... The screen logo can be changed
freely from the Logo Menu (p. 46).
On .......... The screen logo cannot be changed
without a Logo PIN code.
If you want to change the Logo PIN code lock
setting, press the SELECT button and the Logo
PIN code dialog box appears. Enter a Logo PIN
code by following the steps below. The initial
Logo PIN code is set to "4321" at the factory.
Capture
Logo PIN code lock
Setting
47

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lc-wb200

Table of Contents